Ehc rip install

Energy One
S

Savage 1

Active Member
Let's go wire by wire, top post1 goes from solenoid to battery positive.
Post 2 goes from the side of the solenoid to the starter motor.
The Spade terminal should be attached to a green wire coming from the starter button.
 
N

Nwhicks21

Member
Lmk if you can see that video. The link you shared earlier the guy said the top post goes to battery +, and the side post just has the solenoid wire so I’m confused… the green space wire is where it’s supposed to be
 
N

Nwhicks21

Member
Nm I’m sorry I get what you’re saying now, that’s how I have it. I was thinking the solenoid was on the bottom… I’m an idiot
 
S

Savage 1

Active Member
The wire in photo 1790 should be your ground wire. It connects the frame and engine to the negative post. Current return back to the battery.....in short, provides chassis ground.
 
S

Savage 1

Active Member
Nwhicks21 said:
If I remember correct, the wire to the alternator was connected to the armature stud #2?
Click to expand...
Do you know why?

The VR provides current to the battery from the stator.

Usually, the VR is grounded to frame and a single wire goes back to battery positive.

It regulates and rectified current produced by stator. Why would it go to starter?

I'm confused.....
 
N

Nwhicks21

Member
Idk I may be wrong, bc this last wire the one in pic 92 isn’t even big enough to fit on the studs on the starter so it must go to battery but does it go to positive or negative?
 
N

Nwhicks21

Member
Atleast it’s trying! That’s great news! Before all it would do is click so hopefully that means my mainshaft bearings are good in the trans
 
You must log in or register to reply here.
Top