Electrical drama

[snaggy]

I doing a new build with a wire plus harness..all electrics are good BUT starter side is a problem ..on the module i have all green lights but compression release is red (manual compression release)i can hear starter relay clicking but when i press start button there is no voltage at green trigger wire to solenoid WHAT AM I DOING WRONG

 

[HMAN]

Dont use the Wiresplus. Long outta business. Zero service or parts. WildSteedWorx has a rock solid EHC replacement. Dont hack ur harness to install outdated components. Jmo.

 

[snaggy]

Too late mate ....ive already installed it ....any ideas whats going on ....

 

[Rottweiler]

Trace the green wire back to the relay. Check power on the other side of that relay.

 

[snaggy]

Yes i have checked power from ignition white wire from key switch to module and i have power....i have changed relays but nothing different there either....
I have power to the module the relay clicks when i hit the start button but no 12 volts comes out the green trigger wire to solenoid

 

[HMAN]

I cant quite remember cause the install was yrs ago, but I seem to remember a wire had to be added? Yellow seems stuck in the brain but I cant be sure. I'll see if I have any notes in the install folder later today.

 

[Mr. Wright]

Take a wire from the battery and activate the solenoid. This will eliminate that there is a starter problem. And like Hman said, there are better options than wire plus.

 

[knothead]

Starting relay inside the wire plus is probably not working which was a big issue with wire plus.. if everything else is working when you are doing a systems check then I would put a slam button on the starter and crank it from there...hell I road my blue bike for 9 years off the slam button...with that all said it would be a good idea to go aheed and order a new harness and a exel ehc to put on the shelf because the wire plus wont last to long...may last a few years hopefully.

 

[snaggy]

Take a wire from the battery and activate the solenoid. This will eliminate that there is a starter problem. And like Hman said, there are better options than wire plus.

Yes ive done that and had success......so i know its not the starter .....if this module is crapped out what other module would you suggest ....cheers mr wright

 

[snaggy]

Starting relay inside the wire plus is probably not working which was a big issue with wire plus.. if everything else is working when you are doing a systems check then I would put a slam button on the starter and crank it from there...hell I road my blue bike for 9 years off the slam button...with that all said it would be a good idea to go aheed and order a new harness and a exel ehc to put on the shelf because the wire plus wont last to long...may last a few years hopefully.

I replaced the relay inside the module and no success

 

[Snuffy]

Your problems are most likely from the wires plus. I know that’s what you have and all but it’s just not good. If it doesn’t work it doesn’t work. Like Knothead suggested is the best option. Best of luck

 

[snaggy]

Your problems are most likely from the wires plus. I know that’s what you have and all but it’s just not good. If it doesn’t work it doesn’t work. Like Knothead suggested is the best option. Best of luck

I will have one last play with it today then if no luck i will get a new harness .......cheers for everyones input

 

[snaggy]

This module also controls compression release..when i hit the start button it turns red....i have manual compression release so not using automatic CR ...WOULD THAT BE STOPPING POWER TO GREEN SOLENOID WIRE ......how could i bypass this

 

[08 MUTT]

I see what your saying, it might need to complete that circuit to activate starter,,,, Question then would be how to fool it into thinking circuit is complete?