BorgerBigDog
BORN TEXAN
I have no problems with mine,but i want to change it out. I geuss i am a pussy, that shit scares me.I just dont know who to take it too and be comfortable with it when its done...:roll:
Bought the Wire+ for my 04 Chopper
- Thread starter Slider
- Start date
Slider
Active Member
scared me too until I got into it. Clipping those wires were a bit tricky but like Jake says you check, check, and check then clip. You gotta have a good wire stripper, soldering gun, a deutsch plug crimper ($45), lots of heat shrink, a dremel, some patience. It ain't a four hour job but you don't want to do it during riding season.
If you change your own oil/tranny/primary fluid and adjust your own clutch, or can change a throttle/ idle cable, you can do the wire plus. It ain't rocket science.
If you change your own oil/tranny/primary fluid and adjust your own clutch, or can change a throttle/ idle cable, you can do the wire plus. It ain't rocket science.
Slider
Active Member
Well here's some updated pics. Dog's better today.
Pic 1: When you go to the "other side"
Pic 2: Wire + installed
Pic 3 : still got the old ignition module in there. This is how I tested the wire plus before doing the dyna 2ki. Going to clean up that + terminal. Don't like all those connections.
Don't ask me about the "blue" electrical tape. :loony:
Pic 1: When you go to the "other side"
Pic 2: Wire + installed
Pic 3 : still got the old ignition module in there. This is how I tested the wire plus before doing the dyna 2ki. Going to clean up that + terminal. Don't like all those connections.
Don't ask me about the "blue" electrical tape. :loony:
Attachments
Last edited:
bdmridgeback
Low Down Chop Shop
Looks good!!!!:2thumbs: