My spare toy

[Bigtrks]

OK I googled it. There’s a symbol instead of the ohms word it says if it’s one or less or oh well, it’s an open circuit two of them 0 one is a one the 1 (ground )) that was from the wire that plugs into the sensor wire to the speedometer

 

[Bigtrks]

It goes to three and levels out on zero

 

[Rottweiler]

See the symbol that looks like a upsidedown U. Right above the blue plug and the Off switch. Use the 200 or 2000 setting.

 

[Rottweiler]

U tube is your friend.

 

[Bigtrks]

U tube is your friend.

I found it on there waiting for a response from you. Thanks buddy.

 

[liferider]

Still haven’t had time to run my bike over to Strokers, maybe I can do it before Daves in September

 

[SCC007]

Also to answer questions ohm is resistance so key doesn't need to be on. It's looking to see if there is a break in the wire...or if a wired is frayed a lot too.

 

[Bigtrks]

U tube is your friend.

 

[Bigtrks]

OK I finally found my leads that are small enough to get a good reading. With my meter set on 200. Red green and black from the sensor to the speedometer. All read 00.9 is that in the ballpark of what they should read

 

[Rottweiler]

Yes
All wires are good no open wires.

 

[Rottweiler]

You already found the problem the sensor doesn't have the ground / negative to it.

 

[Bigtrks]

Yes
All wires are good no open wires.

OK I’m lost then. It has a new speedo and new sensor. It has power. I guess I’ll take a tape measure and count my miles. Lol.

 

[Bigtrks]

OK I’m lost then. It has a new speedo and new sensor. It has power. I guess I’ll take a tape measure and count my miles. Lol.

 

[Bigtrks]

I would think it Hass to be something simple it better be for me to figure it out lol

 

[Rottweiler]

OK I unplug the sensor turn the key to the on position. And check for power active sensor not the short wire off the sensor the other one. I get 13+ bolts if I ground it to the bike if I ground it to the black wire I get nothing. Does that mean the wire is broke between there and the speedometer?

Here you said the wires going to the sensor Red to black no voltage. Red to ground 13 volts. That tells me the black wire from pin 45 to the sensor is open?? Or pin 45 is not connected to ground? If you look at the middle picture in post #64 the dark black pins should all read to battery neg. / ground. Pins 19,22,35,36,37,38,39,40,42,43,44,45,46,47 & 48

 

[Rottweiler]

I was confused when you said in post 89 all wires read 00.9 ohms from the sensor to the speedo. The green wire goes directly from the sensor to the speedo. The black goes from the sensor to the EHC pin 45 then out pin 40 to the speedo. Red wire goes from sensor to the EHC pin 29 the out pin 50 to the speedo.

 

[Rottweiler]

When you have your meter set to 200 with the leads apart does it say OL and then when you touch both leads together what does it read 00.9?

 

[Bigtrks]

Here you said the wires going to the sensor Red to black no voltage. Red to ground 13 volts. That tells me the black wire from pin 45 to the sensor is open?? Or pin 45 is not connected to ground? If you look at the middle picture in post #64 the dark black pins should all read to battery neg. / ground. Pins 19,22,35,36,37,38,39,40,42,43,44,45,46,47 & 48

Is there supposed to be a

Here you said the wires going to the sensor Red to black no voltage. Red to ground 13 volts. That tells me the black wire from pin 45 to the sensor is open?? Or pin 45 is not connected to ground? If you look at the middle picture in post #64 the dark black pins should all read to battery neg. / ground. Pins 19,22,35,36,37,38,39,40,42,43,44,45,46,47 & 48

i’ll check it out tomorrow. I am off to bed. My alarm goes off in six hours. I did notice today. It would be left side of battery along the frame, a bolt that has a wire eyelet under it and the wires been cut or broken but I can find no wire anywhere, that should go there

 

[Bigtrks]

When you have your meter set to 200 with the leads apart does it say OL and then when you touch both leads together what does it read 00.9?

No, it has the one on the far left and when you touch them together, it says 0 1.3.

 

[Bigtrks]

No, it has the one on the far left and when you touch them together, it says 0 1.3.

I am sorry that I am horrible at explaining things