:2thumbs:
The left side turn signal was arching out in the housing. This all came about when I had taken my front end off of the bike when I had the turning stop issue.
When I reassembled the front end what I did was cut the signal light wires and added individual quick connections to all of the lighting on the bike. So the one that I was arching was the one that the heat shrink didn't cover fully.
I tightened up all of my connections,checked all of the heat shrink for propper coverage,turned my key to the on position and fired the bitch up. I couldn't believe that it fired up so quickly without any problems. Usually its a cold natured pain in the ass but not last night.
Hard to believ that the bike not starting had all to do with the turn signal arching out. Who would've thought.
Thanks for the help and suggestions.
Did that to CC. I do one thing then it leads to another.:lol: :lol: :lol:Good to hear your back on the road Oscar. Your becoming a real wrench now. Take the front end off and next you'll be doing a complete tear down of the bike.:up:
What's a EHC ???![]()
Be carefull with the shrink wrap... its not totally isolating.
Absolutely!:lol: :lol: :lol:good to hear Oscar - presumably you were touching wood when you typed that...
not woodbutcher I hope![]()
sweet!! see Oscar....you already went over your 10 miles for the year!Thanks Chris. So far so good. Actually put 180 mile on it yesterday with no problems.:2thumbs:

Good to hear Oscar :2thumbs: .....bet your wore out from all that ridingThanks Chris. So far so good. Actually put 180 mile on it yesterday with no problems.:2thumbs:
Not at all Mick.Good to hear Oscar :2thumbs: .....bet your wore out from all that riding![]()
