WTB- Forcewinder or D&M spike for '07 Chopper

Status
Not open for further replies.
Brian D

Brian D

Member
Anbody got a D&M Spike or Forcewinder setup for a 117" 2007 BD Chopper?

I'm looking for polished or chrome...no black or other colors. Thanks!
 
HDLARRY

HDLARRY

Active Member
I've got a D&M Twister that I just replaced with an S&S dual port but I'm not sure if I want to let it go yet. It's not the highest performance air filter but served me well for the past couple years and nothing looks better.

 
Last edited:
HDLARRY

HDLARRY

Active Member
Never ran it vertical because I never had any problems with the A/F ratio. At least it was not noticable. Always wondered if it was because of the twist design that it worked better than most spike type air filters.

I was running the Mean Mother exhaust, XXX G carb and stock cam while I had this air cleaner on.
 
HDLARRY

HDLARRY

Active Member
Knotso,

No current picture. It's in the shop right now waiting for a part (long story), dyno tuning and a bracket fabricated for the new 2-1 exhaust system. Hope to get it back next week.
 
kickstart

kickstart

Well-Known Member
HDLARRY said:
Never ran it vertical because I never had any problems with the A/F ratio. At least it was not noticable. Always wondered if it was because of the twist design that it worked better than most spike type air filters.

I was running the Mean Mother exhaust, XXX G carb and stock cam while I had this air cleaner on.
Click to expand...

I was wondering the same thing, I have the straight slots and it runs alot better mounted vertical.
 
Brian D

Brian D

Member
HDLARRY said:
I've got a D&M Twister that I just replaced with an S&S dual port but I'm not sure if I want to let it go yet. It's not the highest performance air filter but served me well for the past couple years and nothing looks better.

Click to expand...
If you decide to let it go, is it just the filter or the whole setup with bracket and everything?
 
HDLARRY

HDLARRY

Active Member
It would be the entire assembly which includes the mounting bracket along with the filter. I should know in a couple weeks if it will be going on the market. Keep in mind that this assembly is over $600 new.
 
barhopper

barhopper

Another round please
Larry, I cut my D&M off at the elbow and slid on K&N filter. Works and looks great. I have my filter and chrome spike if you need an extra.
 
Brian D

Brian D

Member
HDLARRY said:
It would be the entire assembly which includes the mounting bracket along with the filter. I should know in a couple weeks if it will be going on the market. Keep in mind that this assembly is over $600 new.
Click to expand...
Will do. How did that one perform vs the stock cleaner?
 
TCALZ06

TCALZ06

Well-Known Member
Yes but I don't have the brace. My dealer never told me about it when I bought it and so I never used one.
 
Status
Not open for further replies.
Top