wire plus EFI install

[k20crx]

I just got my hands on another 08 bulldog efi

I did the wire plus kit and everything works

Exept

No power to coil
and I got the check engine and fuel like resistor in just fine, that works

But

When I hit the run button the fuel pump primes
And I get power to the coil ONLY when the fuel pump primes...

Help like asap,

Any info just text me 208-546-8502

 

[francoblay1]

Welcome k20crx, check THIS out :2thumbs:

 

[pknowles]

on my 07 bulldog, when you turn the key on, it prime the fuel system. then hit start. sounds like you need to check your wires again.

 

[k20crx]

Checked the wires again, k here's my problem

The orange wire with fuse that comes in the efi wire plus kit goes to pin a1 and that's a red wire right?

Well my pin a1 is green and was the starter soleniod signal wire

What do I do?

That is the only thing I need help with everything else is right

 

[pknowles]

Do you have an electrical schematic for your bike, if not shoot me an email address and I'll send you a copy.

 

[BigDogBro1]

Pay attention to a1 and a-1 designations.

The EHC cuts power to the coil and pump two seconds after you press RUN. Then when you press START, the relay kicks in again and powers the coil and pump while the bike is running.