Ray, I have decided to just add some grease to get it back on the road and get in on the Group Buy and make it a Fall/Winter project.Rhino, how many you need? Are you doing rear or front or both. I have 3 in stock now but won't be doing my rear tire till after the Smoke Out run next month.
I can send them to you in the morning. Again, I only have three for the rear wheel.
Not for nothing, but unless I was totally reading those prices wrong...I cannot see any bearing being premium for that price...and for the work involved with removal and installation and the job they are providing, kind of makes me a little aprehensive.
If I am not mistake, from the Big Dog Dealer, they were $5, and I think less for the front. So that price is probably correct. Definetly not a Timken, but probably exactly what BDM put in all our bikes.
It is entirely possible, and that may be partly to blame for the premature failure. It sort of sucks too because if a bearing shits out good, look what its mounted in...some pretty expensive hubs right??? Bad failures = expensive fixes.
