Thunderheart Coil Resistance
- Thread starter RubWhore
- Start date
RubWhore
Asshole Extraordinaire
Thanks Gas but I`m switching motor and coil mounts wanting to use dyna coils
RubWhore
Asshole Extraordinaire
Cool. Just makin sure. Did you check out Vulcan? They make a nice set of dyna coils made just for them. instead of angled wire hook ups, they are straight out. Allowing you to re-use your current wires.
Thats exactly what I want was looking at last night,you must have one of them there dumaflathcheees for looking at my computer threw the internat only the one I was studying about was chrome when you ordered it was there any consideration nessasary for the ssw plus or will it just fit any evo style
Well the vulcan motor mount is a 3 piece kit. Where as I used the yankee motor mount with the vulcan coil mount and coils. The yankee motor mount is a nice looking mount and is only 2 pieces. HOWEVER, it took some CNC modification to make it all work right. Hence why I say "Custom don't bolt on"
Well I had to have a 45* canter put on the top leading edge of the yankee mount. It had a vertical edge sticking up over the face of the vulcan coil mount that didn't look good. I also had to have the bottom cut out to accomodate the key, and a new rear piece where it mounts to the frame. More detail and pics can be found in my Phoenix thread under customizing.
RubWhore
Asshole Extraordinaire
I looked at that what I didnt understand was the motor mount one half inch away from the frame which means it needs a spacer or use the original camel toe(not an option) or too tall and had to be cut down.
Showtime
Member
Ray your correct 3ohm will do her...The coil in your bike should be a Crane as mine is. I believe they are 3 ohms.
I had a whole new piece cnc'ed versus using the spacer idea.