I have an 05 BDM chopper that I am building from the ground. I am putting the swingarm back and the spacers do not seem right. I have a service manual for it but nowhere in the SM does it cover the swingarm (it also may be that my download of the SM was not complete). I have two spacers each a different size, and the fatty goes on the left side of the bike. BUT there is still about a 1/16 or 1/8 inch gap and the bolds seem to be grounding. I DID NOT put torque to it, and wanted to check my resources first. Is this a case of tighten it down (anyone know where the torque specs are at for this if that is the case?) and or do I just take up the slack. Any help would be greatly appreciated. Rick