small seal on shaft baker RSD behind cluth?

[frenchie]

hello, I need some information?
I am in the process of replacing the baker clutch bell by a complete bandit clutch kit.
has uninstallation, behind the bell, I saw this small seal, I think it is placed behind the clutch bell, but I'm afraid to crush it to tightening ...
where exactly is it installed? I put a picture
Thank you for your help

 

[FrankBDPS]

Try to contact Andrew Barnes at Barnes performance motorcycles in Endwell New York. He used to have a web site on the internet. Good luck!

 

[Mr. Wright]

If your talking about the little o-ring behind the clutch basket, yes, it just slides on the shaft and it is pinched as you tighten the hub nut. Don't forget lots of red lock tight on the hub nut.

 

[frenchie]

A big thank-you.
it's really nice not to feel abandoned, I asked the question to baker who did not answer ....
by cons when I try to load a picture of even reduced size, it does not work at this time ...

 

[frenchie]

hello

how many shim do you use on the springs of the pressure plate for the installation of a complete bandit cluth kit?
I put 3 shim of 050 " to try, total 150" I do musculation but with the clutch and 3 shim it is already very hard to disengage!