right hand control switch

[bigchazz]

Sirs....looking for a right hand control switch, the board that goes under the mounting. Any one have one of these or know where I can get one? I dont need the housing, just the eletronic board....Thanks for any help

 

[MARV]

Maybe biker garage 101

 

[Brew]

I've seen them on ebay, contact Shovelheadkicker. He sells them quite often...

 

[Kiwirider]

You mean this? I just had to repair mine as the brake sensor solder had come loose. Yea Shovelheadkicker on ebay would probably have one.

 

[Th3InfamousI]

Kiwi, quick question. That Black Wire where/how does that disconnect?

Trying to take the board out in one piece. I installed some new grips and low and behold nothing works on the right side anymore :bang:

 

[CURDOG]

Kiwi, quick question. That Black Wire where/how does that disconnect?

Trying to take the board out in one piece. I installed some new grips and low and behold nothing works on the right side anymore :bang:

I recently had mine off to inspect the connection for corrosion while chasing my problem. Did you make sure the pin connector was on good when you put it all back together? It's a little difficult to get your fingers in there on the connector. I had to take a small screwdriver and gently push it sideways on the connector to get it on good.

 

[PitBull43]

I have the same problem, Any chance that a bad connection would have something to do with the bike not starting when i push the button? The clicking sound (suppose the comp releases) makes noise but no start. I installed a push button on the plunger to start it.
Same problem, changed grips and the whole thing came apart. If there is achance it is that part i would love to find one.