replace with utima - connections ?

[hayseed]

i am going to put an ultima motor in a mastiff (its rolling frame) and i am wondering how the electrical connections and oil lines will work/connect,,, will the old crank sensor from the original S&S be needed... how will the the tach get its readings ? also will the oil tank and lines connect in the same ? if anyone has done this i would appreciate some guidance
:bang:

 

[Brew]

Bump it to the top...

 

[MARV]

Ultima uses a cam sensor. Basically same as a dynatek 2KI.

Tach wire comes from that.

Ultima used to have detailed instructions on their site

 

[john sachs]

i am going to put an ultima motor in a mastiff (its rolling frame) and i am wondering how the electrical connections and oil lines will work/connect,,, will the old crank sensor from the original S&S be needed... how will the the tach get its readings ? also will the oil tank and lines connect in the same ? if anyone has done this i would appreciate some guidance
:bang:

Oil lines will work the same.
No provision for a crank sensor. Nose cone ignition is usually supplied with their engines.
Tach wire off ign. system.
Electrical connections: Ultima igniton separate, easy to wire. All other connections SHOULD be easy to figure out.
John

 

[hayseed]

thanks -- will post as the project progresses