Rear Wheel

[mseifert]

I finally got my rear wheel back after getting bearings in it. I have spacers and washers that I forgot which went where and need help if anyone can tell me please with placement. Thanks

 

[HMAN]

Spacers with lip goes towards bearing. Thinner spacer between caliper bracket n frame.

 

[mseifert]

I finally got my rear wheel back after getting bearings in it. I have spacers and washers that I forgot which went where and need help if anyone can tell me please with placement. Thanks

I must have screwed up because it is not going back on it is sloppy so I will have to find a pro to do it. Finding a shop that works on Big Dogs will be haed. Thanks for the info

 

[HMAN]

Ur closest good wrench will be in Camden. Not sure if he taking any work but he may pop in the thread. @knothead is ur man.

 

[mseifert]

It would be nice to video chat him! Thanks!

 

[kickstart]

Check your PM

 

[knothead]

You have 3 wheel spacers...the large wheel spacer goes on the pulley side with the lip facing the bearing and the other end of it against the swingarm.

The other 2 spacers goes on the opposite side...the spacer with the lip goes toward the bearing...the other spacer that has no lips at all goes between the caliper bracket and the swingarm.

Sometimes even with the spacers in the there will be a little slack and that because the swingarm is sprung...once you put the axle in and tighten it up the free play is gone...rear axle torque is 65 ft lbs

 

[mseifert]

I did that and it loose tighten down

 

[mseifert]

I found out what the problem is I need to know where this spacer goes?

 

[knothead]

I found out what the problem is I need to know where this spacer goes?

It goes between the pulley and the swingarm...lip toward bearing

 

[mseifert]

Thanks everyone for the help I got itback together after finding the second missing spacer forthe outside left. Now I need to adjust forthe drivebelt