loose tail light assembly

B

bscott

New Member
Hello,

I have a loose tail light assembly on my 2003 chopper and was hoping someone could help with instructions on how to tighten it back up. It is the right rear tail light and I'm assuming I need to pull the LED board and there will be a tightening nut in the housing but just wanted to make sure. Thanks in advance for your help
 
Little-Boo

Little-Boo

Well-Known Member
Troop Supporter
Pop the lens out, pull out the guts (light) and use a box end 1/2 inch and tighten up. If you can find the bolt on the inside you will have to take the strut off. The bolt might be between the fender and the strut, or look and see if there is a bolt between the tire and the fender going towards the light housing and tighten it up. I don't have a manual for 03 maybe someone will give you a better idea. But that is what I would look for.

Carlos :old2:
 
Last edited:
C

Conejo

New Member
Little-Boo said:
Pop the lens out, pull out the guts (light) and use a box end 1/2 inch and tighten up. If you can find the bolt on the inside you will have to take the strut off. The bolt might be between the fender and the strut, or look and see if there is a bolt between the tire and the fender going towards the light housing and tighten it up. I don't have a manual for 03 maybe someone will give you a better idea. But that is what I would look for.

Carlos :old2:
Click to expand...
How does the lens come off? 2004 chopper
 
Mr. Wright

Mr. Wright

Knows some things
Conejo said:
Smart ass?? Not an answer?
Click to expand...
Doing an introduction and telling a little bit about yourself is only polite when joining a forum.
There is a little slot on the edge of the lens, put a screwdriver in it and twist, the lens will pop right out.
 
You must log in or register to reply here.
Top