installed o2 bung

Energy One
Status
Not open for further replies.
J

johnny2

Member
I took off my front pipe milled in a 7/8 hole and tig welded on a stainless steel o2 sensor bung to make tuning the mikuni hsr 48 a little easier I have an air fuel digital guage to tell me the mix in real time so with tape on the throttle and marks at 1/4 1/2 3/4 and full open I will know what area is rich or lean. when I ordered the bung I also got a plug and selected the long bung to not restrict the pipe so bad. imho this is the cats meow for tuning (unless you have a dino in your garage)
 
alhall88

alhall88

UAW
ordered my r&b racing pipe with the 02 sensor bung as well but I still need to order the gage. Who's gage are you going to use? r&b's setup is sweet buts around $350 for the meter and sensor with harness. Nice thing is you can mount it permanent if you want.
 
alhall88

alhall88

UAW
Thanks larry I think thats the way I'm going to go because I really don't want to mount a gage on the chopper. The handheld unit will do carb bikes and all I would have to do is screw in the sensor, tune it then remove sensor and put plug back in.
 
HDLARRY

HDLARRY

Active Member
alhall88 said:
Thanks larry I think thats the way I'm going to go because I really don't want to mount a gage on the chopper. The handheld unit will do carb bikes and all I would have to do is screw in the sensor, tune it then remove sensor and put plug back in.
Click to expand...
That is exactly the way I've been using the LM-1 since I bought it a few years back. Glad I could help.
 
J

johnny2

Member
I was just going the temp rout too. My box from 15 years ago says Intellitronicx corp. 216-521-9796 . I dont recall who I got it from but it gets used 4 to 5 times a year and has made a lier out of allot "pro" tuners with good noses and ears. I remember it was cheap like 40 or so may have come from J-C Wittney
 
Status
Not open for further replies.
Top