OK, so I got bored waiting to take the bike in for the trans repair. so I thought, why not match up the control levers with the pipes to the pegs.
#1 drilled levers
#2 drilled pipes
mask and mark for holes. center punch first. use a small bit to drill starter hole.
then use the size bit for the finished hole.
then use a step bit starting from the back side first, this will increase the hole depending on how far you drill into the peg. then dill the front side.
if you look inside the finished holes you will see the rings cut by the step bit. it really looks great in person. my next thing will be to use the step bit on my levers to get the same ring effect.
#1 drilled levers
#2 drilled pipes
mask and mark for holes. center punch first. use a small bit to drill starter hole.
then use the size bit for the finished hole.
then use a step bit starting from the back side first, this will increase the hole depending on how far you drill into the peg. then dill the front side.
if you look inside the finished holes you will see the rings cut by the step bit. it really looks great in person. my next thing will be to use the step bit on my levers to get the same ring effect.
:2thumbs:
