can i use either speed sensor opening?

[03pitdog]

cant get screw out of my speed sensor now stripped I think previous owner used red Loctite. I have a baker 6 speed and I see another sensor port with cover on it right next to one sensor is in now. can I use this opening for new speed sensor and cut wire on this one? thanks for any help

 

[03pitdog]

Got answer from baker transmissions. I can not use the other speed sensor port it is for 5 speed transmission and i have 6 speed w od so would not line up with gear to read. if you have a six speed w od got to have speed sensor in outside port. Just info for any who may have been wondering also. Thanks Donnie

 

[woodbutcher]

thanks for the good info.

 

[Sven]

Propane torch the red locker at the trans case and watch out you do not melt the aluminum. Trick word of the job is 'swirl' around the sensor hole. Remove a cold wrap [a frozen wet shop rag] and warp the sensor. Take the frozen box end wrench and time that hot case when it's time to yank on the wrench.

Gimmy at torch, do I need the other hole, get outhe way. :roll:

Dis here's a for Dr. Finddahole

 

[03pitdog]

Thanks sven for info. Donnie