broken baffel

E

Eric

Banned
I've been hearing a ratttle on occasion finnaly got to the point i could hear it @ idel looked in v&h big radius found that my cut baffle on top pipe was broken around bolt that holds it in pipe, bolt is still in there keeping baffle from sliding out, baffle just moving around & making noise i've got another baffel yea the same from differant set of pipes will change it soon, what would cause this with only 1250 miles on them??? is this a normal thing if you cut them in half, no support on front of baffle or what ??
 
G

Gas Man

Cool isn't cheap
Calendar Participant
No its a normal thing on any V&H pipe I have ever found! EVER!! Even on my neighbors honda. His baffle on his V&H has broken twice this year. JUNK I tell ya.

Many times, you can just run a bolt and nut thru it if the hole in the baffle is still there.
 
Nomad2day

Nomad2day

Longhair Redneck Geek
My big radius bracket broke in half to boot. Those pipes are still laying in the garage floor somewhere seeing how I put the R&B Racing 2-1 pipe on..
I got a couple of cut baffles laying around too..
 
Slinger2

Slinger2

Active Member
Years ago I had a baffle shoot out of the pipe when on the 275.
Good thing no one was around.
:bang:
 
BBChopper

BBChopper

Supports 2 Disabled Vets
Troop Supporter
Gas Man said:
You're bikes are trying to tell you something... it hates the baffle
Click to expand...
Damn that was deep Brotha:eek:
I'm gona go see what mine has to say Aboot Dat right now....................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................Gas she said your clutch plates were abused and that’s why I had to use mine instead but she appreciates your carrier very much, thank you. Oh she said your bike iz hot??? Not sure about that I think she haz a cold or a hang over….:eek:
 
G

Gas Man

Cool isn't cheap
Calendar Participant
She must be drunk cause those plates were golden, before she puked her juice all over them :lol:
 
turk1

turk1

Member
Is there a thread for removing baffles and cutting them down from a V&H big radius 2 into 2 exhaust pipes? I tried the search but no luck? I am sure it is simple but sometimes these easy projects can turn into a cluster fuck. Never hurts to ask before diving in sometimes.
 
W

woodbutcher

Mr. Old Fart member #145
Staff member
remove the back half of the heat shield, remove the screws from the back of the pipes that hold the baffles in, remove the baffles (can be difficult), cut to a length of 4 3/4 inches with a hack saw, and re-install.
 
Chopper Dave

Chopper Dave

SIICK!!!
yeah I cut mine down a couple of years ago.....down to around 4 3/4 inches...now I have them welded in..being that my bolt broke on mine that holds the baffle in....no more problems as House said....:up:
 
turk1

turk1

Member
Well I cut the baffles down to a total length of 4 3/4" and did not like the sound of it. So I took the baffles out all together. It sounds great but today is too wet to test drive. Anyone have major issues with them out?
 
Chopper Dave

Chopper Dave

SIICK!!!
with no baffles in your pipe...you will have no back pressure.....thats why I cut mine down.....I like the sound...but to each their own....alot of people run without baffles....
 
You must log in or register to reply here.
Top