Be careful

[jaybird]

Make sure you pull the dogs front fender (4-1/2" BOLTS) before you pull into the condor motorcycle wheel stop. It'll leAVE A MARK

 

[Bubba_BigDog]

Ouch...

 

[chacha]

Gotta have the right wheel cup for the Condor -- I think they have three sizes. They make one specifically for long fenders. Never had a single problem myself....

 

[snake1962]

Gotta have the right wheel cup for the Condor -- I think they have three sizes. They make one specifically for long fenders. Never had a single problem myself....

Yep, Condor has one special for choppers - low fenders and smaller width front tires. Was at a bike show where they were demo'ing them and were using a K9 and it had clearance - no problem with the fender and they were moving the bike on and off it all 3 days of the show.

 

[05chop]

Even with the correct chock I had to grind 1/2 inch off both sides then used spacers to center chock.

 

[jaybird]

Thanks for the info

 

[Little-Boo]

Even with the correct chock I had to grind 1/2 inch off both sides then used spacers to center chock.

I did the same as you did. I have two chocks one on the lift and one on the trailer. The one on the lift is perfect, however the one on the trailer was about 1 inch or so to long. I just took cut about 2 inches off. That worked for me. :2thumbs:

Carlos