and again the clutch

Chong

U-235
I checked the nut. Amazing! I've never seen anything like this before!! The nut was indeed loose! Thank you all so much for your advice and attention to my problem!! I'm so glad this forum exists!:)
Awesome !

I use the Type F trans fluid. In the primary.

Clutch plates used in the factory set up . Are rated for dry use. Or can be in oil. As others said.
So the oil is technically for the chain as stated.
 
Last edited:
I have one more question. I hope I haven't bothered you!)) How do I tighten this nut? I struggled for two hours. I secured the clutch basket, but the center part is spinning! I tried putting it in gear, but that didn't help. I pressed the clutch plates. This secured the center part a little. BUT, naturally, I can't press the clutch plates hard enough with my hands to stop the center part of the clutch basket from spinning. How do I secure the center part of the clutch basket? Thank you.
 
Top