'04 Daytec Chopper pivot shaft
- Thread starter Blaster
- Start date
- Status
francoblay1
The Spaniard
Bob,
I just emailed a couple Manuals to you, check your Inbox in a few minutes.
I just emailed a couple Manuals to you, check your Inbox in a few minutes.
Dude! you just missed out. I just put mine back together a couple days ago.
Do you have the bearings that go in the swing arm?
I run down to the shop and take a pic of want I can see.
Do you have the bearings that go in the swing arm?
I run down to the shop and take a pic of want I can see.
Ok, I couldn't find anything in the Manuel that shows the swing arm. So the first picture is the view from behind. note on the right that the shaft is bigger than the rest of it. It will fit into the swing arm and push up to the bearing. On the left the shaft is the same size all the way to the end, and pushes up to the bearing.
In this picture, between the chrome spacer and the swing arm, you can see the bearing. The chrome spacer is 5/8'' wide, plus I would say a .050 cone shape tit, that looks like the end of the bearing. And the side that touches the bearing, there is a cone shape inset, for the bearing to fit into.
In this picture, you can see the bearing between the swing arm and The frame.
In this picture, you can see how the shafts larger end fits into the swing arm.
You have my number, call me if you need to
In this picture, between the chrome spacer and the swing arm, you can see the bearing. The chrome spacer is 5/8'' wide, plus I would say a .050 cone shape tit, that looks like the end of the bearing. And the side that touches the bearing, there is a cone shape inset, for the bearing to fit into.
In this picture, you can see the bearing between the swing arm and The frame.
In this picture, you can see how the shafts larger end fits into the swing arm.
You have my number, call me if you need to
I wouldn't do it for just anyone. Bob and I go way back. Almost a year and a half now.:lol:
Almost a year and a half now.:lol:
Sorry, I guess that would help.
The small part of the shaft is 1'' and the big part is 1.400''. The spacer is 1.750''
You will need to get the bearing to measure the length. Get with the Kaptin on them. If he doesn't have them, he can tell you where to go or what will fit.
wsworx@gmail.com
The small part of the shaft is 1'' and the big part is 1.400''. The spacer is 1.750''
You will need to get the bearing to measure the length. Get with the Kaptin on them. If he doesn't have them, he can tell you where to go or what will fit.
wsworx@gmail.com
Also the bolts are fine thread, the diameter of the ID of the bearing.
francoblay1
The Spaniard
Rep Points for you Shannon :2thumbs:
- Status