has anyone installed the soft clutch ramp and ball on a 2004?

[8ball]

clutch getting a bit stiff, I switched out quite a while back to a Rivera Primo and it has worked great for a long time. Started being unable to get that easy into 1st shift, after trying many times took apart the ball and ramp side and checked out the works but it all looked good, but of course after I put it back together it was tougher working than when I started. Figured if I'm going back in I might as well change the throw out bearing and switch up to the soft pull if it is applicable to the 2004. Any input will be appreciated

 

[knothead]

Sounds like your clutch pushrod slack needs to be readjusted....about 1/8 to 1/4 from slighty touching and then take the slack up in the cable....as far as hard to pull sounds like the cable needs lubed or you need a new cable..

BAKER TBK-56L is a easy pull ball and ramp for the 04 model and other pervious year Baker, Jims or Ultima Transmission....they are around 100.00..they do make a difference on the clutch pull

 

[8ball]

that's just the info I needed thanks guys

 

[HMAN]

A dry cable will pull tight af. Lubing the cable won't hurt. I put in the heavy duty throwout from Baker when my Pitbull chewed up the stock one. Always a good choice if you are already in there.

 

[Mr. Wright]

Lubeing the cable will help a lot. I install an extended lever in my 04. On the ball ramp lever. It's so easy to pull now, my arm is getting weak and flabby.

 

[awg]

I thought that was caused by old age.

 

[8ball]

A dry cable will pull tight af. Lubing the cable won't hurt. I put in the heavy duty throwout from Baker when my Pitbull chewed up the stock one. Always a good choice if you are already in there.

sounds like solid advice will do exactly that