Rivera Primo Clutch

Mickmorris

Mickmorris

Well Known Member
Supporting Member
Anyone have one or removed one of these Rivera Primo clutch packs? Little different than a Harley. Getting ready to take it off this evening. Any tips would be appreciated! 30985C80-EC63-497A-A8B8-BE35DB6E6663.jpeg
 
knothead

knothead

Second Chance Customs
Just remove those 4 bolts in the picture like a full turn at a time skipping around as your taking them out ...by doing this it helps not to bend your spring plate....do the same when putting the bolts back on....do not over tighten them....just bottom the bolts out....snugged up and bend the tabs...

Remember the clutch hub nut is left handed threads....install with red loctite and torque to 80 foot pounds
 
Mickmorris

Mickmorris

Well Known Member
Supporting Member
knothead said:
Just remove those 4 bolts in the picture like a full turn at a time skipping around as your taking them out ...by doing this it helps not to bend your spring plate....do the same when putting the bolts back on....do not over tighten them....just bottom the bolts out....snugged up and bend the tabs...

Remember the clutch hub nut is left handed threads....install with red loctite and torque to 80 foot pounds
Click to expand...
Awesome! Thx Knott!
 
Jwooky

Jwooky

Well-Known Member
knothead said:
Just remove those 4 bolts in the picture like a full turn at a time skipping around as your taking them out ...by doing this it helps not to bend your spring plate....do the same when putting the bolts back on....do not over tighten them....just bottom the bolts out....snugged up and bend the tabs...

Remember the clutch hub nut is left handed threads....install with red loctite and torque to 80 foot pounds
Click to expand...
They upped the clutch hub nut to 150 ft lbs
 
You must log in or register to reply here.
Top