MyDogPete
Active Member
2001 Pit Bull, with S&S 107. I'm not a mechanic by no means other than oil changes, plugs and plug wires so I'm looking for some advice.
The back top right 1/4" Allen Head Screw that is on the top rocker box cover has oil spewing out past it almost like the screw is not even in. All of this was taken off and replaced a couple of years ago in New Mexico when I had new gaskets and O rings done on push rods.
From what I Think I Know there is a flat 1/4" washer along with another flat 1/4" rubber covered washer that's on the top side of the box. What I'm wondering is could the fix maybe be made with just removing the one screw and the (2) old washers and replacing the (2) washers whit new ones and re-torque screw and take care of the problem, or is there something else that may be going on under the top billet box causing problems.
Amazing how chit breaks when your bike has been sitting a week and you decide to take a ride.
Tks
Mike
The back top right 1/4" Allen Head Screw that is on the top rocker box cover has oil spewing out past it almost like the screw is not even in. All of this was taken off and replaced a couple of years ago in New Mexico when I had new gaskets and O rings done on push rods.
From what I Think I Know there is a flat 1/4" washer along with another flat 1/4" rubber covered washer that's on the top side of the box. What I'm wondering is could the fix maybe be made with just removing the one screw and the (2) old washers and replacing the (2) washers whit new ones and re-torque screw and take care of the problem, or is there something else that may be going on under the top billet box causing problems.
Amazing how chit breaks when your bike has been sitting a week and you decide to take a ride.
Tks
Mike
