European light change

[AsKarO]

Hi all.
I have a 2009 Ridgeback (NO efi) imported from U.S.A. and i live in Italy then i need to change the rear and front light, I need to know if someone have the electric wire schematic (i have the 2007 wire diagram...it's the same???)and if someone have already make this operation...
The rear light have 3 wire but i need to install a 4 wire light (position/stop and separated orange turn light..)
Thank you.

 

[francoblay1]

You can integrate All-In-One, position/stop & turn signal in the same bucket. So you will end up with no extra lights hanging of your fender. :up:

 

[aspen874]

Franco, is your man to talk to, there are several members here on the forum from Europe,
hopefully someone will be able to give you a "how to".

 

[Germanbiker]

I seperated the wires from the brakes levers and put them on a switch to operate the brake lights. This will not harm your EHC.

I was given this advice from a member here who does a lot of homologations in Germany.

My EHC is still ok after 3 years of operation.

There are CE marked rear lights that you can install in the OEM housings:
http://www.brands4bikes.de/beleucht...zum-einbau-ohne-metallgehause-paar-e-gepruft/

Buona fortuna!

Jochen

 

[Brew]

Good to see ya Jochen...

 

[AsKarO]

I seperated the wires from the brakes levers and put them on a switch to operate the brake lights. This will not harm your EHC.

I was given this advice from a member here who does a lot of homologations in Germany.

My EHC is still ok after 3 years of operation.

There are CE marked rear lights that you can install in the OEM housings:
LED Rücklicht/Blinker Einheit COLORADO zum Einbau, ohne Metallgehäuse, Paar, E-geprüft. - Rücklicht- / Blinkersets - Rückleuchten - Beleuchtung - Motorradzubehör großer Marken

Buona fortuna!

Jochen

Thank you for information!!!:up:
Unfortunately i have already buy 2 pair of new bullet....i have only one problem....I need to remove the front forks to change the turn lights???

 

[francoblay1]

Thank you for information!!!:up:
Unfortunately i have already buy 2 pair of new bullet....i have only one problem....I need to remove the front forks to change the turn lights???

Can you post a pic? I don't think you need to remove the forks at all!

The screw that hold the turn light to the "forks" is located inside the lights bucket...

 

[AsKarO]

Can you post a pic? I don't think you need to remove the forks at all!

The screw that hold the turn light to the "forks" is located inside the lights bucket...

Oooh...that's good!!!
Sorry for misunderstand...i have make a question ..Because I have not yet done this operation..tomorrow i look inside the light and i try...
Thank you for this informations!!!:2thumbs:

 

[francoblay1]

Oooh...that's good!!!
Sorry for misunderstand...i have make a question ..Because I have not yet done this operation..tomorrow i look inside the light and i try...
Thank you for this informations!!!:2thumbs:

Prego. :2thumbs: