WTB pcb board

wyldride26

wyldride26

Member
What's up guys I'm lookin for a left pcb board. This is what I got goin on. Last Thursday I was changing out my grips from stock ones to spiked ones and when I got it all back together my horn wasn't working. Now my left trun signal is working and my hi and low beam is working also but just not my horn. Now I might add that I did the wires plus upgrade to my bike and everything was working for a while after, it's just now that I changed my grips my horn isn't working. Anyone got any ideas or a pcb board bacause that's what I think my problem might be?

Thanks allot guys
 
mobsta

mobsta

Well-Known Member
Did you check the wires going into the plug to the pc board?The pins break easy on these wires.just a thought....
 
wyldride26

wyldride26

Member
No I didn't I've been super busy with other things goin on but as soon as I get a few mins I'll be sure to do that thanks alot I'm gonna check all the wires there
 
wyldride26

wyldride26

Member
I was just thinkin When I check those wires goin to the plug if one of them is broken how am I supposta re connect the wire into the pin in the plug because I'm almost gonna bet that's my problem because everything worked till I took it apart to install my new grips
 
You must log in or register to reply here.
Top