vance and hanes question

[mightymaro]

i just installed a set of v&h big radiaus 2 into 1 pipes on my 07 K-9 . with the baffle in it is way to quiet. with the baffle out , its just a touch to loud when on a long trip, is there any thing i can do to the stock baffle to get more tone . what would it be like if i drilled the flat part of the baffle. any body else have this problem , need something in middle .. thanks Robbie

 

[Splitlog]

I have the same on my 08 Ridgeback...yeah with it out a little loud but it falls on its face at low end also...You need to search around this forum. I have seen in detail on how to do just what you are asking..knocking out the center plug..I would find that thread and then contact them with questions..

 

[woodbutcher]

not sure about 2into1 but with 2into2 you can pull the baffle and cut the length in half and re-insert the front half and it's just about right.

also, please do and intro in the introduction section. tell us about yourself and your scoot.

 

[Splitlog]

cant cut the length on a 2-1...can knock out the center but that is it....again there
is a thread on this.

 

[mightymaro]

where is the other thread at ? ive looked and cant seem to find it . any help would be great.. thanks Robbie