Twisted 12MM Spark Plug Wires

Twisted 12MM Spark Plug Wires Exoerience

  • Installed - No Problems

    Votes: 42 73.7%
  • Installed - Immediate Problems

    Votes: 9 15.8%
  • Installed - Problems Developed Over Time

    Votes: 4 7.0%
  • Installed - Ruined the EHC

    Votes: 2 3.5%

  • Total voters
    57

mymastiff

Active Member
Had them for several months with no issues and they look great! No performance difference that I notice, all about looks!
 

09wolf

Member
Twisted plug wires fit 2009 Wolf??

Anyone with a 2009 Wolf try these wires? Read earlier post about them being short for one member.
 

dnespolo

Active Member
Anyone with a 2009 Wolf try these wires? Read earlier post about them being short for one member.
Yes they are short, I sent them back and they made me a pair longer to fit the wolf, I just order them the same length of the original ones.
 

rasdes

Active Member
Update on my issue with these wires....I called Crowe Cycles and talked to Andy, explained my previous problem with these wires, told him I loved the look and asked if they could do anything to correct the RFI issue that causes the TACH to go crazy. They made me a "special" set with 2500 OHMS, installed them last night, did not take the bike on a road test but idled / revved until it was warm and there was no problem with the TACH. Hopefully, a road test will indicate they're good to go....
 

gnturboray

Member
Update on my issue with these wires....I called Crowe Cycles and talked to Andy, explained my previous problem with these wires, told him I loved the look and asked if they could do anything to correct the RFI issue that causes the TACH to go crazy. They made me a "special" set with 2500 OHMS, installed them last night, did not take the bike on a road test but idled / revved until it was warm and there was no problem with the TACH. Hopefully, a road test will indicate they're good to go....
Any new news? I love the look of the wires but I'm hesitant to buy a set with all the problems Im reading about. I'm still running my original EHC on my 05 Chopper. Motor has been built with 131rwhp and it is strong! Im also running an S&S IST ignition with factory plug wires. No issues what so ever and was going to slap a set of Twisted on just for the looks but not so sure now. :loony:
 

rasdes

Active Member
No issues so far......I've put about 150 miles since I installed the new 2500 OHM wires, runs great and the TACH does NOT flucuate.
 

chili08k9

I will buy the 1st round
Can someone tell me what to do about the coil being way too small for the wires???? do you just tighten up the wires or is there a spacer or something
 

rasdes

Active Member
I may be wrong but if it's a stock coil, they should fit. I've never seen any posts that indicate differently
 

chili08k9

I will buy the 1st round
Yea thats what I thought Rick, but the post inside my coil are tiny compared to the end of the wires, I just didnt know if everyone squeezed the ends so they were tight, around the post. I got new clamps and it all looks sweet. just dont know what I will loose with the mis fit. Oh yea my bike is a EFI if that makes any differance. Thanks for any help.
mike
 
Top