Tribal foot brake.

[Daddycool]

Ok, so I get this awesome set of tribal foot levers from Shovelhead Kicker (great guy BTW) and put them on my bike. The brake lever is rotated a small amount forward more than the stock one was. My question is; is there a way to adjust that up 3/8 to a 1/2 inch. Seems the lever isn't as high as I'm used to. I don't see any way to adjust it. Thanks!

 

[dingo]

Same thing with the vision levers.....mine fit / locked together in a certain way and i did not see any way to adjust.......on the bright side, I got used to them pretty quick

 

[RADAMS445]

The pin is for match alignment from side to side...you can leave the pin out and adjust to were you want.

 

[Daddycool]

The pin is for match alignment from side to side...you can leave the pin out and adjust to were you want.

Yes that is one way to do it but I'd be afraid I'd crush the plunger into the master cylinder without the pin to stop it.

I was just wondering if I got one that was machined incorrectly. I now doubt that.

 

[Splitlog]

Mine is the same. And yes you will get used to it and won't notice the difference after a while.

 

[Daddycool]

yep it's only off a small amount.

 

[Little-Boo]

yep it's only off a small amount.

In that case just buy you some platform shoes

Carlos :lol:

 

[RRRUFF]

Mine was the same way, after you ride it awhile you won't even notice it any more.

 

[Daddycool]

In that case just buy you some platform shoes

Carlos :lol:

I did briefly think about it!