TRANSMISSION

[PINKY]

CAN someone tell me a easy way to remove a tranny out of a 05' big dog Mastiff?please pinky

 

[liferider]

easiest way is to bring it to a mechanic! Might not be the cheapest or best, but definetly the easiest!!!! :roll:

 

[Bobby Schulz]

Easiest way is to disconnect the battery, and leave the inner primary hooked up to the engine.
Take off the outside primary cover to take off the chain,and clutch assy. Then loosen the bolts to the trans only and then move on to the other side to remove pipes,wires,clutch pushrod etc as needed and let the starter hang.

Make a mark so that you can put the wheel back into alignment before you loosen it and then loosen the rear wheel to get enough slack in the belt to slip it off the trans.

Then remove the 6 bolts that holds the trans to the frame and take special note of where the shims are located between the trans/frame so that you can put them back.

Call me if you need a rebuild or any help,
Bobby 704-989-2294

 

[PINKY]

Thank You for the Info Pinky

 

[erldawg]

easiest way is to bring it to a mechanic! Might not be the cheapest or best, but definetly the easiest!!!! :roll:

Smart azz :roll::roll::roll:

Easiest way is to disconnect the battery, and leave the inner primary hooked up to the engine.
Take off the outside primary cover to take off the chain,and clutch assy. Then loosen the bolts to the trans only and then move on to the other side to remove pipes,wires,clutch pushrod etc as needed and let the starter hang.

Make a mark so that you can put the wheel back into alignment before you loosen it and then loosen the rear wheel to get enough slack in the belt to slip it off the trans.

Then remove the 6 bolts that holds the trans to the frame and take special note of where the shims are located between the trans/frame so that you can put them back.

Call me if you need a rebuild or any help,
Bobby 704-989-2294

Way to go Bobby...The resident tranny expert...:2thumbs:

 

[PINKY]

Hey there i was just trying to do this a easy way if there is on? but no problem because i can do this. I am a wrench on my own bikes. And run my own shop But thanks for the advice... Not LOL