The bike finally runs.

[Joe Tulanowski]

Have you Tried Curtis at WSW. He has them, check out the link below

http://www.wildsteedworx.com/index....info&cPath=65_68_174_175_276&products_id=1184

Carlos

Okay. I got the rebuild kit and a new boot. After taking FIFTEEN screws out to get master cylinder off, when I opened it there was at least a half teaspoon of crud in the bottom!! I'm talking solid crud that had to scrape out! Getting ready to tear it apart and change out the parts now. My question is........is there a way to blow out the line from banjo to banjo remove any crud that possibly worked it's way into the line? Air compressor with a small nozzle perhaps? Don't want to the rebuild and have shit still in the line. Thanks! Joe

 

[BWG56]

If it was that bad, you might want to go a little further than the lines and clean out the calipers also.