Technician ?????

[Splitlog]

Notices tonight on the front cylinder/right side that a piece of gasket was hanging out where cylinder goes against case right behind where pushrods go into case. Runs good and nothing leaking. Should I be worried?

Thank in advance

 

[bdmridgeback]

Your fine, alot of these motors are assembled that way. The gaskets are just a bit over sized.

 

[Splitlog]

Thanks Jake. It was just hanging out. About 1/8 x 2" a little pucker factor at the beginning of the riding season. Still loving my wireplus!

 

[Raywood]

Just make sure you warm up the motor before you take off cause the pressure can blow them out also :2thumbs:

 

[Splitlog]

Thanks for the input. It was hanging out and I bent it over and it snapped off. about a 2" long piece..the back side had a curve to it as if it was the entire gasket.