tach

[SNMOTORDOG]

does anyones tach start to not read right when bike gets hot sitting in traffic and then works fine when going along and bike cools down a little.

 

[V]

If its a idle and the idle drops below 950 rpm's the tach will flash. Its a alert to warn you of low idle and low oil pressure. If thats the problem you just need to turn the idle up a bit.

 

[SNMOTORDOG]

thanks,but that i know.the tach just jumps around reading nothing up and down even when you rev it

 

[rasdes]

Twisted Spark Plug Wires

Had the same issue caused by the big red twisted spark plug wires, changed back to OEM, problem disappeared.

 

[Nukeranger]

Rick,

I am curious if you had the EMI/RFI Suppression Twisted Spark Plug Wires #TF-7 because I do and I have not had any issues.

Huw

 

[SNMOTORDOG]

no rick,i have taylor spiral cores.have no problems going along just when you idle for a while and engine gets hot.once i get moving along and engine cools down ,tale is fine again.

 

[rasdes]

Rick,

I am curious if you had the EMI/RFI Suppression Twisted Spark Plug Wires #TF-7 because I do and I have not had any issues.

Huw

Huw,

That is the same model I had...TF-7 RED, several others on the below forum had the same issue discussed in another tread I started, they swapped their wires and all is OK. The problem may be isolated to a bad batch, I do not know. I have sent several emails to the seller (crownscustomcycles) on EBay, no response on the warranty / RFI questions, nothing but crickets!!

 

[Nukeranger]

Rick,

Damn the luck! Sorry you and others had issues. I must have been lucky thank goodness. They look good on the Dog and I am glad I didn't have to go through this frustration and find another supplier.

I agree that it had to be a bad batch of wires.

Sucks,

Huw

PS Thanks for your service.:flag: