Still no running lights or tach???

[Chopper117]

Hey Mob, just switched them and that was the problem. :2thumbs: I have a bad LED light. Thanks for narrowing it down for me!


Raywood,
When I turn the key on I get no fault lights on the EHC. Now is this because I have a bad LED light or is something else going on here?? :loony: Thanks.

 

[bdmridgeback]

As long as you can unplug the turn signal board and everything powers up, you should be golden replacing the board. The EHC buy passes a circuit that has a short on it. Now that it is gone, everything will power up normal.

:2thumbs::2thumbs::2thumbs::2thumbs:

 

[Raywood]

Hey Mob, just switched them and that was the problem. :2thumbs: I have a bad LED light. Thanks for narrowing it down for me!


Raywood,
When I turn the key on I get no fault lights on the EHC. Now is this because I have a bad LED light or is something else going on here?? :loony: Thanks.

Seems you should have had a fault lit on the rear turn signal if it was bad.

 

[mobsta]

glad i could help.i try when i can i keep it as simple as possible.i have an 04 masstiff and i have had every problem known to these dogs and many more.replace the leds and ride it like you stole bro.

 

[Chopper117]

Thanks for all your help fella's! I went and bought a new LED board and all of my lights work now! :2thumbs:

And thanks for that diagram Raywood that's good to have!

 

[bdmridgeback]

Almost everytime I have been at hand with a Dog problem where it wont start, There never are any fault lights on.

I think those lights are just there to look pretty in the dark when the bikes do run!!!!