Starts

Energy One

porterwalker

New Member
I went out the bike started right up .Went for a ride for a few hours came home parked the bike in my driveway went back out a couple hours later to put the bike away it wouldn't start only the flashers came on I tested the battery and it test good
 

Sven

Well-Known Member
1. I turn the key on, push the start button and nothing.
2. I turn the key on, push the start button and it just cranks away.

3. I turn the key on, and the lights all look normal as is a peek at the black box and those colored LED's.
4. I turn the key on, I get no lights, just blinking flashers.

5. I came home, fiddlefucked with the bike after my last ride... it was the last thing I did on the bike.
6. No, I just walked away each time and here we are.

7. I tested the battery and the number reads 12v.
8. I tested the battery and the exact number on the static read is ________ fill in the blank.

Choose the best numbers.
 

Mikeinjersey

Well-Known Member
I went out the bike started right up .Went for a ride for a few hours came home parked the bike in my driveway went back out a couple hours later to put the bike away it wouldn't start only the flashers came on I tested the battery and it test good
Welcome from NJ
Recheck your battery voltage at rest. If it's 12.8 v or above check your connections for tight and clean(very important). If it's below 12.8 recharge it. If it starts after it's charged check the voltage while running. It should be high 13's or better but not over 14.5. If not troubleshoot your charging system. If it still doesn't crank with a full charge you need to troubleshoot the starting system. If all checks out it could just be your battery going south and not holding a charge.
Lot's of posts to be found on this subject for all different Big Dogs.
 

1 B.M.F.

Well-Known Member
Check your battery connectors and check your voltage. 12.8 is what you want or more. I’m betting they were loose or battery is bad.
 
Top