Long Island
Member
ok....ok....ok....what's the trick to remove the bottom bolt of the plastic side cover? Top two unscrew right out. Bottom one just seems to spin in what looks like a rubber nut? hmmmm....:angry:
side panel cover bolts
- Thread starter Long Island
- Start date
pins
That's not a bolt its a solid piece of aluminium pin pushed in a gromet.
Just pull the 2 of them strait out.
Big Dog had a recall to replace the bolts with gromets and pins to have the plastic:flag::flag::flag: covers float due to cracking from the bolts being tight and the vibration.
Have a good one
That's not a bolt its a solid piece of aluminium pin pushed in a gromet.
Just pull the 2 of them strait out.
Big Dog had a recall to replace the bolts with gromets and pins to have the plastic:flag::flag::flag: covers float due to cracking from the bolts being tight and the vibration.
Have a good one
dingo
First 50
Correct !
The 04 and 05's (not sure about other years) used a "well nut" system. When a well nut is spun (i.e. the nut is no longer secured so it is free spinning), you have to grab and hold the nut through the rubber grommet with some form of plier in order to unscrew the bolt. Google "well nut" and you will get a better idea.
francoblay1
The Spaniard
X2, I had the same problem with my K9... grab tight with plies the botton and spin the top.... (I did need my wife to help me) two persons iwill make it easier.
Once out get in touch with WSW and buy a new set (better set up) HERE or contact KaptinAmerica or Raywood, booth are member here in the Forum.
:2thumbs: