Pushrods

spinalfever

New Member
I started asking about this in the pushrods how to but thought this is a more appropriate place to post it.
I'm getting oil leaking our of my pushrods I previously thought it was coming our of the exhaust but upon further inspection found it bubbling out of the chrome around the pushrods. The question is I adjusted them and now they leak did I over adjust?
 

Attachments

BWG56

Guru
Are you sure the O-rings are in the right place when you put the tubes back together? Looks like one of the O-rings is sticking out in your picture at the top of the tube.
 

chacha

Chaff Your EHC!!
Calendar Participant
This is almost certainly the result of an o-ring that is not seated and not/not the result of adjusting the pushrods.

Pop the pushrod cover keepers and make sure the o-rings are fine good and properly seated. :cheers:
 

spinalfever

New Member
I'm such a dumbass I'm sorry for wasting anybody's time. When I put everything back together after adjusting them I put the chrome covers on without putting the internal sleeves back up found this out while inspecting the o rings. Thank you guys for all your help I'll try to keep the brain farts to a minimum.
 

Little-Boo

Well-Known Member
Troop Supporter
If your referring to the top pic that's actually a drip of oil but I will check the o rings
That is not a big drip of oil, that is half of the O ring sticking out. Either that or your oil is real dirty. To me that is definitely where your oil is coming from :2thumbs:

Carlos :whoop:
 
Top