PUSHROD ADJUST?

denver0511

denver0511

Member
Yeah, i've read it, the only part i'm confused on is that he sais turn to the left, and it doesn't seem to be working righr, but when i turn it the right it does seem to work, so am i doing it right, clock wise, or counter?
 
V

V

Guru
Top tube counter clock wise should extend.
Bottom tip clock wise should extend.

Its just like a bolt and nut. :hi:
 
Little-Boo

Little-Boo

Well-Known Member
Troop Supporter
denver0511 said:
when you are extending your pushrods, do you turn clock wise or counter clock wise?
Click to expand...
Why are you extending the push rods. :eek: If you are adjusting your push rods, I hope you loosened them up first. Don't try to adjust the push rods by just extending them. You have to do the whole step to fully adjust them. By that I mean you should loosen up the rod you intend adjust, take up the slack and adjust (extend) 24 flats or four full turns. The valve has to be in the right position (closed) to do that. If you don't know how to do the adjustment I would not fuck with it, :spank: you could end up with a bent valve or push rod or worse.:bang::bang: Not to bust your bubble, but from the sound of you question, I don't think you know enough to be fucking with the valve adjustment. :loony:

Just my opinion, and opinions are like assholes everybody has one. :roll::roll::roll:

Good Luck

Carlos
 
You must log in or register to reply here.
Top