Please Help, WirePlus Installation

Energy One
bryant1609

bryant1609

Active Member
Today I took off to complete my WirePlus installation. Installed and everything works but the Front Brake light switch. It worked before the installation and the Rear Brake works fine. Started Bike and it runs fine. Checked all other lights and switches and all of those work fine. Checked Oil light which is also B33 which is also Orange and that work. Toned out B36 for the old key switch and also tried it to right in case and nothing. I have the right wire as per the instructions which is B26 but no when I hit the front brakes.:bang::bang::bang::bang: I think I found an extra Red wire B30 snd gave that a shot and still NO GOOD.

Please someone help me get this working please.
 
N8KAM

N8KAM

Well-Known Member
Do you have B-26 (front brake) tied together with A-4 (Rear brake) "both are Orange wires" these 2 are connected together and then routed to position 4 in plug #3..
 
N8KAM

N8KAM

Well-Known Member
You might find the wire for the front brake switch has separated from the pc Board in the right control. open it up and see.. I had that problem when i first got my bike. it is adjustable in the right control so it might have moved out of position also.. if all is ok Then i would check the continuity between the position 4 of plug #3 and the plug in the Right hand control.
 
N8KAM

N8KAM

Well-Known Member
bryant1609 said:
But brake worked fine before installation, and bike is three years old.
Click to expand...
Cant say why... Its a mechanical (magnetic) switch at the control. if it works with the rear then the issue is with wire B-26 or the pc board/switch.
 
You must log in or register to reply here.
Top