On the road again!

[Wills67]

Just finished another round of PM. Forks, brakes and neck bearings since I was already there.

during

after back in the pound:2thumbs:

 

[zer0t]

Wow, your garage is beautiful and nice work on the bike.

 

[Wills67]

Thanks Bro!

 

[Mad Dog]

+1:2thumbs:

Wow, your garage is beautiful and nice work on the bike.

 

[Th3InfamousI]

Whats with the Oil Stains on the floor? CLEAN IT UP :lol:

Seriously nice looking garage

So what did you do with the forks?

 

[tommy666]

Get a pic of the lady on the dog! Nice garage by the way!

 

[Raywood]

Good job

 

[Wills67]

Thanks guys. Eric, I just did the seals and oil on the forks. Overall not a bad job. Tommy, wife asked the same question. "Why didn't you wait to get a picture with me on the bike?" Who knows, could be POTM material??

 

[Th3InfamousI]

Thanks guys. Eric, I just did the seals and oil on the forks. Overall not a bad job. Tommy, wife asked the same question. "Why didn't you wait to get a picture with me on the bike?" Who knows, could be POTM material??

What did u use to press the seals on? I'll be doing that this winter, saw a post on here about using a couple feet of PVC and a few couplers to make a press.

I see the lady in the background, didn't catch that earlier :up:

And why you tearing into your bike now It's riding season here in Dallas!

 

[Wills67]

Hey Eric, Wouldn't have, but I had fork oil running up the legs pretty bad. Bought the bike with 10K on it 2 years ago and just turned over 17K. Doubt they were ever looked at before. I used the PVC as described in the thread on fork maintenance along with a 2 pound hammer. Only took about 3 or 4 whacks and they were in. Pipe is sitting in the garage if you need to use it.