NO SPARK - Troubleshooting Tree

[1BADK9]

So again, how do we get a sticky on this? Seems worth it considering so many guys have no spark issues, and I know I've hunted this thread down and hotlinked it a few times.

PM Tim he can make it a sticky, think Ray can too.

 

[germank9]

I've got a ignition problem at my Harley this days. The problem was the cam timing sensor but i'fe searched 2 days for the problem.

If you have a two wire cam sensor it should be round about 1 k Ohm resistance.

Mine as round about 1 M Ohm - but - when i connect a multimeter i have had round about 1 V AC - and that should be so said the manual. But the resistance was to high and so the ignition stops some times to work.

If anyone will have such a Problem with a 2 wire sensor use the restistance for diagnosis - not the voltage when the engine is running like the manual says...

 

[francoblay1]

I have tried writing to someone about my (wrote for help a few days ago) "Big Dog Chopper" on the Forum and
have not received any reply. Perhaps I am not writing in the correct area.

I am having a problem with the bike stalling out seconds after it starts (starts great by the way). Seems the problem started a few months ago, I was having an intermittent "Headlight Problem". Took it to a local bike shop, bike would not stall out for him of course, and headlight came back on by itself.

Took bike on a 500 mile ride a few weeks ago, (I did take a big chance I know) bike ran great but now the headlight goes out completely (bulb checks out good, even put a new bulb in ---N/G). A few local rides later stalling problem comes back big time. Thats when stalling issue came back.

The red light on the aluminum box (under seat) where the trouble-shooting plug is located has a red light that I think should be lit when the key is turned in the on position, and/or when the on/off switch on the handlebars are activated, red light only comes on if I hold the the on/off switch and push the start button at the same time, motor cranks, red light comes on and bike starts up great, then in a few seconds the red light goes out and the bike stalls out. I cycle the key on and off press both start buttens again, bike starts, red light light comes on, then stalls out again in a few seconds...........By the way headlight does not work at all now, all other lights/turn singles are working correctly..........HELP !!! HELP !!! HELP !!! What does EHC Module stand for and where is it located........???

Hey guys I need sum major help here getting ready for strugis. I was riding today and hit a nice bump, my big dog chopper shut off, tried to restart but bike won't start it's trying but seems like it has no spark can any1 help

Start HERE :up:

"Dos Pajaros de un Tiro!"

 

[BWG56]

Start HERE :up:

"Dos Pajaros de un Tiro!"

:roll::roll::2thumbs: