No power to my ignition switch

[Guillaume]

Well charge my battery 13.4 check my ignition switch with my little lamp but there coming no power ,clean the two connectors on my ECM , still nothing happens ,anybody have a other idea what to do.
Guillaume

 

[BWG56]

I don't think there is power to the switch, all it does is complete a ground circuit to feed back to the ECH

 

[Guillaume]

But if turn the key no happens thing , when I check it my light come on very little

 

[Guillaume]

Is it possible that my ECM have to be replaced.

 

[BWG56]

When you turn the key on, do any of the lights on the ECH come on?

 

[Guillaume]

Nothing no light on the ECH

 

[awg]

Well...I would think you should see at least one led lit on the EHC. To show you that you have power.

 

[BWG56]

Do any of the lights work? headlight, turn signal anything? brake light

 

[BadDawg Bill]

I don't think there is power to the switch, all it does is complete a ground circuit to feed back to the ECH

Check the wires on the switch to see if they are grounded... there are no positive wires going to the switch.... You may have a bad switch or ground going to the switch...

 

[bdm7250]

Check the wires on the switch to see if they are grounded... there are no positive wires going to the switch.... You may have a bad switch or ground going to the switch...

Does your key have a lot of play in it when in the run position?

 

[Mr. Wright]

Go back to the battery. look and see if you missed a wire when you put it back together.

 

[Guillaume]

Well the bike start again , have know idea what happens but turn the key and everything came on ,Did everything what you guy,s told me to do ,Check my battery again when the motor was running but it stay on the same reading 12.7.
So check my stator today and see if that have to be replaced .
But anyway like to thank all of you to help me out ,And merry Christmas with your fam.
Guillaume

 

[cdogg556]

That's what my EHC started doing, everything would be fine, shut it off and try to start it and nothing, no lights on the EHC, nothing, then wait a few hrs and everything would work, drove me insane! Replaced it with Doc's ESC and no problems since, good luck Guillaume and Merry Christmas!