My winter project

Energy One
Shredder

Shredder

Active Member
Lee, My project for last winter was to get tons of stuff chromed, wheels, triple trees, almost anything that hadn't been chrome already. The cam cover is an aftermarket piece I bought from Big Dog, the rocker boxes are stock.
 
G

Gas Man

Cool isn't cheap
Calendar Participant
Rick said:
Gas are you saying as long as the check valve is in the line it workes regardless of where it is?? Also you and I & Shredded have the Dougherty Power pacc. How did you run the line witht he check valve in it into the back of the Power pacc? I saw in a previous post where you had said to run it to ground??? I was planning on going into one of the threaded plug holes on the back of the power pacc. Shredder and Gas how are you running yours??
Click to expand...
I just wrote something on it for proflyer... check it there.

I have had my rear ran to the floor for a while... sense my 500 mile
 
Shredder

Shredder

Active Member
Gas, the Ness I used as well as Sul's Sumax retails for about $200. I see these things discounted everywhere I go, probably special orders that weren't picked up. I went to my local BD dealer at Christmas time to spend a gift certificate and they had the Ness set on clearance for half price. I couldn't pass that deal up.

Shredder
 
R

Rick

Active Member
Gas Man said:
Rick
http://www.bigdogbiker.com/forums/technical/3164-rear-head-check-valve-gas-man.html

Shredder... I see... wel its something to consider... not that I need anything more to do... :lol:
Click to expand...
Thanks Gas once again you have answered all my questions. The next time I am in MI, you will be the first person I buy a beer for!!! Or if you make it to CO to ride to Rockies with me and Proflyer, drinks are on us the entire time your here (can even hook you and the wife up with a place to stay). :up: :up:
 
G

Gas Man

Cool isn't cheap
Calendar Participant
Sweet Rick.. thanks bud!! Its appreciated. Somehow I think it will be me there first cause no one in their right mind comes to michigan unless they have to. :D
 
Shredder

Shredder

Active Member
Rick,
My dealer (Full House Cycles) has been doing the work. The R&R on the engine was quoted as 20 hours of labor. Bottom line is I am paying about $2,600 for the labor, powder, and Diamond cut on the engine. Tranny is costing around $500 for labor and powder.
 
Last edited:
G

Gas Man

Cool isn't cheap
Calendar Participant
I was afraid you were going to say that Sul... if I would have thought about it... could have had the dealer do it when they did my S&S boxes! OH well... they look sweet.

Got pics of yours installed?
 
G

Gas Man

Cool isn't cheap
Calendar Participant
I hate when dat shit happens...

Hopefully you catch the bastard that left you high n dry!! :lol:

How is the caliper mounting on that side? Have to weld anything to the swingarm? Did you have the 360 on the rear before?
 
Fibersnake

Fibersnake

Banjo Playing PsychoBilly
Well I happen to be down at Full House yesterday and did get a chance to look at Shreder's project and I must say the picture do not do it justice.

Very very nice is all I can say and I am sure he will be very happy to get it on the roads up around our neighborhood.

Got to go take my BD down to the dealer today and have some work and the recalls done and hopefully I can get another peak of the Shred Ride.
 
You must log in or register to reply here.
Top