Motor mount and coil setup
- Thread starter alhall88
- Start date
Chopper Dave
SIICK!!!
Looks sick Al....:2thumbs:
alhall88
UAW
Well when I ordered all the parts I also ordered a set of coil covers and just had the covers painted. So after I get the cover back from paint and start wiring everything up I realize the bigdog ignition is to short. So its either counter bore the backside of the front coil plate or find an ignition. Since the bigdog is a pc. of crap anyway I hunt down an ignition. After the initial install I think the coil covers look like shit. So off everything comes and put all big dog stuff back on and now sand the coils smooth and take them to paint. After that everything went ok and I only had to take off 1 more time when I crossed the 2 coil wires. I was told it didn't matter about the polarity but it does.
thought i would these this pic's up, i have the matching breather to the coil hanger. i converted a horn cover in the coil hanger. if you start looking around you will be surprized how many large horn/coil cover from both metric and vtwins can be used.
sorry, now i can not get the pics to post. check "my biker photos" there is a shot of it there.
sorry, now i can not get the pics to post. check "my biker photos" there is a shot of it there.
Last edited:
cavracer21
Active Member
the coils look great, they work any better then the stocker???? i cant wait to get over and check um out they look sweet.
by the way...did you ever get your bike runnin right again?????????
by the way...did you ever get your bike runnin right again?????????
Both of them look real nice. Hats off to the both of you, nice job.:2thumbs: