Matching gas cap

[keverett91507]

Finally got gas cap done. Matching the new cam cover. like I say can't find it improvise and make it work

 

[keverett91507]

Cam cover

Cam cover

 

[keverett91507]

Better pic of cover

Cam cover

 

[Brew]

Sorry brotha but I can't make it out. Is it an iron cross? Ok I can see the cam cover... If the gas cap is the same then thats bad ass...

 

[leandean99]

I see these on JP cycles, did u buy just the cross and attached it to the cam cover or did u buy the one with the cross on the gas cap cover and then attached that to cam cover?

 

[francoblay1]

 

[keverett91507]

Thanks Franco gotta figure out how to enlarge the photos. I bought 2 has caps from j&p cycles. Took both apart. Had to take stock cap apart and rig it to the new cap. Took other cap apart an it fit cam cover perfectly after a trip to the drill press

 

[Viking]

If you have a sissy bar pad holder with just BDM on it, I'll trade you for mine with the cross...



And if you have the stock primary case covers we can swap these too:

 

[keverett91507]

I have the primary covers already. If I had a bdm pad I would sure trade you but I'm looking for a sissy bar setup myself. I give away the stockprimary covers or I would hook u up sorry

 

[Viking]

I have the primary covers already. If I had a bdm pad I would sure trade you but I'm looking for a sissy bar setup myself. I give away the stockprimary covers or I would hook u up sorry

No worries, keep up your good work.. :2thumbs: