Kill switch wont work
- Thread starter Boon
- Start date
BadBrad
2005 Pitbull
Kill switch works with WP, but you don't have to press the run button before pushing the start button.
Boon,
Your first post should be in the "introduction" forum. Tell us a little about you, your bike, your family, where you live, ect. You'll find a much more welcoming response to your questions that way. Like mentioned before, give a little more detail on the bike. Do you have the original EHC or something else, like a WirePlus? Year, make and model. And welcome to the pound from south Mississippi.
Boon,
Your first post should be in the "introduction" forum. Tell us a little about you, your bike, your family, where you live, ect. You'll find a much more welcoming response to your questions that way. Like mentioned before, give a little more detail on the bike. Do you have the original EHC or something else, like a WirePlus? Year, make and model. And welcome to the pound from south Mississippi.
Use to work and havent changed anything other than a new switch when it quit working
BadBrad
2005 Pitbull
In most cases, the only time the tach lights flash is when your RPM's get under 900. Can you hear the rpm's drop any when you press the stop switch? One way to test is press and hold the stop switch. Once the lights start flashing, continue to hold the stop switch while you throttle up the rpms. If they stop flashing, then somehow the stop switch is draining enough power to lower your rpms. Just not quite sure how to fix it, but hang in there and someone will come up with something.