Inverted forks 02 Pro Sport Need Help.

Energy One
W

wezxwezx

Member
Also, picked up new O-rings for the caps (now I have 98 spares LOL) and the 2 rubber wiper seals. I greased them up and wrapped electrical tape around the bushing end of the tube so it was higher than the edges of the bushing recess and overlapped the tape in a descending pattern so once started the wiper seal and aluminum holder just slid “downhill” onto the tube. Waiting for my Chinese seal driver (half the price of the Motion Pro one) and then I’m ready to reassemble.
 
W

wezxwezx

Member
Well LOL...I was a little concerned when the Motion Pro knockoff Chinese seal driver said “40mm-41mm”, and sure enough, it does not fit 41mm forks! When you engage the sliding ring it is so tight on the forks it doesn’t move! LOL Will be getting a refund for that and I ordered a real Motion Pro one...$44.99 on eBay. My Goldwing forks are also 41mm, so it makes sense to go ahead and buy the real tool. Ya get what ya pay for!
 
You must log in or register to reply here.
Top