How to swap out your Big Radius baffles

Status
Not open for further replies.
G

Gas Man

Cool isn't cheap
Calendar Participant
I'm sorry but I don't recall. I have sense sold them and don't have any of the info with me anymore.

Go introduce yourself properly and pin the map though
 
T Mack

T Mack

SUCKER FREE
is it bad to run without baffle?
I would rather just take mine out like i did with my V&H Big Shot Short Shots..
Super loud.....!!!!
 
G

Gas Man

Cool isn't cheap
Calendar Participant
T you could also cut the stock baffles down. That is what alot of guys have done.
 
Nomad2day

Nomad2day

Longhair Redneck Geek
Gasman,
As far as getting your bike dyno tuned with big radius pipes on it, would you be better off having the whole baffles in to get the most out of tuning the bike?
Neil in Tenn
 
V

Vegas

Well-Known Member
T Mack said:
is it bad to run without baffle?
I would rather just take mine out like i did with my V&H Big Shot Short Shots..
Super loud.....!!!!
Click to expand...
You will lose a lot of your low end torque. I found the best setup was to cut them in half. Gives you more of the best of both worlds.
 
Nomad2day

Nomad2day

Longhair Redneck Geek
Kirk927
Do you mean lengthwise on the cutting in half? I know a stupid question but I had to ask.
Click to expand...
If they are 12" long cut it in half so they are 6" long. One end has a tab with a screw hole in it to attach it to the pipe. Throw the other end away.
Neil in Tenn
 
MistaBob

MistaBob

Member
I just installed the Big Radius kit on my bike this weekend. Its not as loud as the kit I had on there before but its a good sound. How much better does it sound with no baffles at all vs with the baffles gas man found? What are the pro's / con's and differences?
 
Status
Not open for further replies.
Top