So if you don't like or have bruised shins or are tired of getting harassed about your horizontal plate...
So you look something like this now.
So pull the state plate first with the four allen bolts.
Now pull and remove the 4 bolts holding the backing plate to the support arm.
(you don't need to remove the LED hood, but consider doing so if you plan on spraying the board with sealant)
(also note, yes mine is already flipped but needed to be replaced so now I make the how to)
This is the said supporting arm
Now lets take a looky at the before and after
Left is the new one not setup for vertical
Right is the old one that has been ran vertical
New/not yet flipped. You can see the "pre-drilled" holes for the flip
Old/has been flipped
Just to show you... I labeled the Horizontal (H) and Vertical (V) holes.
Horizontal
Veritcal
So you look something like this now.
So pull the state plate first with the four allen bolts.
Now pull and remove the 4 bolts holding the backing plate to the support arm.
(you don't need to remove the LED hood, but consider doing so if you plan on spraying the board with sealant)
(also note, yes mine is already flipped but needed to be replaced so now I make the how to)
This is the said supporting arm
Now lets take a looky at the before and after
Left is the new one not setup for vertical
Right is the old one that has been ran vertical
New/not yet flipped. You can see the "pre-drilled" holes for the flip
Old/has been flipped
Just to show you... I labeled the Horizontal (H) and Vertical (V) holes.
Horizontal
Veritcal